Други поможите кто может...
сервер падает, обновленный - вот лог:
[spoiler=""лог""]./srcds_run -game left4dead -maxplayers 8 +map l4d_hospital01_apartment -ip xxx.xxx.xxx.xxx -port 27015 +sv_lan 0 -nomaster -debug
Auto detecting CPU
Using SSE2 Optimised binary.
Enabling debug mode
Server will auto-restart if there is a crash.
Running a benchmark to measure system clock frequency...
Finished RDTSC test. To prevent the startup delay from this benchmark, set the environment variable RDTSC_FREQUENCY to 2992.000000 on this system. This value is dependent upon the CPU clock speed and architecture and should be determined separately for each server. The use of this mechanism for timing can be disabled by setting RDTSC_FREQUENCY to 'disabled'.
#
#Console initialized.
#Game.dll loaded for "L4D - Normal"
Server is hibernating
ConVarRef test_progression_loop doesn't point to an existing ConVar
Game supporting (2) split screen players
maxplayers set to 14
Unknown command "r_decal_cullsize"
Unknown command "mat_bloom_scalefactor_scalar"
Network: IP xxx.xxx.xxx.xxx, mode MP, dedicated Yes, ports 27015 SV / 27005 CL
---- Host_NewGame ----
Host_NewGame on map l4d_hospital01_apartment
ConVarRef room_type doesn't point to an existing ConVar
Executing dedicated server config file
Commentary: Loading commentary data from maps/l4d_hospital01_apartment_commentary.txt.
[S_API FAIL] SteamAPI_Init() failed; unable to update local steamclient. Continuing with current version anyway.
./srcds_run: line 368: 16171 Ошибка шины (core dumped) $HL_CMD
Cannot access memory at address 0xb7fa9658
Cannot access memory at address 0xbfd9c7f0
/home/xa0s/l4d/l4d/debug.cmds:3: Error in sourced command file:
Cannot access memory at address 0xb7fa9658
email debug.log to [email protected]
Вск Мар 8 14:02:41 MSK 2009: Server restart in 10 seconds
Вск Мар 8 14:02:44 MSK 2009: Server Quit[/spoiler]
Подскажите куда копать...
srcds: error Ошибка шины
-
- Нович0к
- Сообщения: 5
- Зарегистрирован: 29.03.2008
Один.
Перезаливал снова и снова. не помогает :(
Перезаливал снова и снова. не помогает :(
-
- Нович0к
- Сообщения: 5
- Зарегистрирован: 29.03.2008
возможно, но серв чистый, Debian lenny 5.0
Такая же проблема, на Etch все было норм после обновления до Lenny стал падать.
Где то на англоязычных форумах на тыкался, что дело в обновленном libc-2.7.so
На выходных буду перестанавливать ось обратно на Etch, о результате сообщу.
Кто то может уже решил сию проблему?
Где то на англоязычных форумах на тыкался, что дело в обновленном libc-2.7.so
На выходных буду перестанавливать ось обратно на Etch, о результате сообщу.
Кто то может уже решил сию проблему?